Published: Dec 05 2018
Dock lines, also known as docking or mooring lines, provide a very important connection for boats – landing! Often the most overlooked equipment on a boat, having the appropriate type and lengths of dock lines on board will make your return from sea – and reconnection to terra firma - safe, efficient, and, most importantly, keep your boat where you docked it and away from other vessels.
For boat renters, knowing some basic nautical terms, checking on-board dock lines, knowing how to properly use the lines, and learning basic dockside courtesies will keep your boat — and others — safe and free of dings and scrapes, or worse. Using time-tested techniques to securely dock your boat, under any weather or other condition will ensure that your boat is safe and secure and that other vessels and docking facilities are protected.
Dock lines that match a boat’s length are important. Lines that are too short or not strong enough will not do the job; lines that are too long or too thick for deck fittings just get in the way. A good rule of thumb for sizing dock line is one-eighth inch of line diameter for every 9 feet of boat length. Regarding length, bow and stern lines should be about two-thirds of a boat's length; spring lines should equal the boat's length.
The first thing to know about lines in general is this: aboard boats, most material that landlubbers would refer to as “rope” is called “line” by boaters. Using the right term will at least make you sound like a mariner! Below is a short glossary of some terms you should know, followed by suggestions and techniques that will help you dock like a pro:
Bollard: A short, heavy post at the edge of a pier onto which dock lines are tied.
Bow line/stern line: A docking line leading from the bow or stern.
Chafe: The damage caused on lines by contact with wood, steel, or concrete on docks, piers, bollards, chocks, or cleats. Chafing is reduced by using material (called chafing gear) like garden hose to protect lines from abrasion.
Chock: A metal fitting on a vessel through with docking or anchor lines are led.
Cleat: An anvil-shaped fitting to which lines are made fast.
Eye: A permanent or temporary loop in at least one end of a line, made by splicing strands of the line in and out of itself.
Fender: A cushion placed between boats and docks to prevent hull damage.
Heaving line: A light line with a weighted end to which a larger line is attached, used to throw the larger line to a dock or another vessel.
Pier: A structure extending from land out over water, used for landing vessels.
Spring line: A line running to the dock forward from a boat’s stern, or aft from the bow; relieves tension on bow/stern lines and prevents a boat from surging fore and aft.
Before getting underway, ensure that docking lines are aboard and that they are free of chafe, kinks, mold, mildew, dry rot, or excessive fading. Nylon lines are best for docking because they are lightweight, offer superior strength and stretch, and are easy to handle.
Using dock lines can be a challenge, particularly if a dock is crowded. These guidelines will help in landing your boat efficiently and in a manner that protects other’s property:
A major part of dockside courtesy is “dipping the eye,” one of the easiest techniques to learn, and at busy marinas, almost a necessity. Dipping the eye allows boats whose dock lines share the same piling, cleat, or bollard with yours to depart when they wish, without disturbing the dock lines of remaining boats.
To dip the eye, pass the loop (eye) of your line up through the eye of the other boat’s line, and then drop it over the bollard, pile, or cleat. Though the eye of your line is above the other boat’s mooring line, its position is below theirs; when the other boat is ready to leave, their line will easily lift over yours. Since your line is below theirs, the other boater simply takes their line in and departs.
Nautical tradition and common courtesy suggest that when on a dock and not otherwise engaged in docking your boat, it is good form to offer to assist an incoming vessel.
Having the proper sizes and lengths of dock lines on board and knowing how to use them will make your voyage, any intermediate stops, and your return to home port efficient — and safe. In addition to dock lines, it is most prudent to have on board a line of substantial length (75 to 100 feet) for use as a towline, to assist getting a disabled boat (either yours or another vessel) to a safe harbor.